FS: Rims 8.5" x 16"

[budgetracer]

ACT "LS Mesh" rims by Ronal as seen in Grassroots Motorsport, Nov. / 2002, page 155. 8.5" x 16", 5 bolt, 114.3mm.(4.5")pcd, 5.75" backspacing, very clean, will fit Camry's, Talons... Asking $700.; can be seen at Solo 1 open house this Sunday- George Trach OMSC or e-mail miniac@sympatico.ca, can e-mail pictures.

[Taylor]

Folks, these are some light ass 16" rims.. I had George come by and we tried to shoehorn them on my MR2 (With coilovers) and while there was plenty of room in the rear, in the front, I would have needed a 5mm spacer just to get the RIM to sit on the hub, let alone a tire on it too. (MR2's with Teins basically can only do about 7.5" if the offset is just right, it's just a wierd thing with the design of the car and coilovers) MR2's had like 3 coils for the springs, so the perch sat REALLY high up. Coilovers the perch is an inch or two so above the hub.

Anyhow, my point. When I lifted them I was shocked. For such a large wheel, they were quite light.

Man I would have loved to have 8.5" on the car.