FS: Chevy Engine

[Robv]

For Sale:
Rebuilt chevy 350 engine.
Never started, has been siting for years, not seized (oiled and rotated frequently)
Balanced and blueprinted, flat tops, Double hump heads w acc holes, corvette cam.
Including Quadrajet carb, stock intake,waterpump.
95% assembled. $1950 OBO. 905 975 8865.

Will trade for EJ25 engine.

[ADAM]

do you have any pics of it,

what kind of power out put does it have?

[Robv]

I can make a couple pics and email then to you.
Just email me so I have your address.

Power output ? Hard to say, but with a good set of headers and intake I'd guess around 300. (At least that's what the builder told me).

Rob.

[ADAM]

sorry forget it...i see that it is carburated now...

[RedRabbit Racer]

Adam - once you have whipped the weasels with your turbo you should try putting a V8 in your nissan and see how that works. there was a red nissan with a 350 in the regional racing until last season.

[Dave]

once you have whipped the weasels

Hey, I resemble that remark! :p

[ADAM]

yeah i know...a Lt1 would be a perfect fit into a 240..though it would have to be twin turbocharged thus cannot be carburated...

[GR8 Ride]

There are plenty of aftermarket fuel injection systems available for the Chevy small blocks.

On the lower end, these can be around $1000 or so, going up to about $2500 for some higher end units.

I just don't know if your 240SX could handle a twin-turbocharged Chevy small block though....500 or 600 HP could be too much for the chassis.

Pretty easy to get a Chevy small block into the low 400's naturally aspirated...and fairly cheap too.


Pat

[ADAM]

there are several stock chassis 500-600 hp turbo 240sx's out there, and lots in the 400 range..