PDA

View Full Version : ZX1 grease


MARC W
01-29-2008, 08:40 PM
Anyone know where i can find ZX1 grease in north america?

finboy
01-30-2008, 03:37 PM
you tried....


http://www.zx1store.co.uk/contact.cfm?cfid=3920367&cftoken=80696967


© TEAM ZX1 LTD
Unit 20,
Millbrook Business Park,
Jarvis Brook,
Crowborough,
TN6 2RS
United Kingdom

Tel: (+44) 01892 669828
Fax: (+44) 01892 669832


Your Name:
Your Email Address:
Subject:
Message:


whats the application?

how bout this stuff???

REDLINE Synthetic CV-2 Grease


Red Line CV-2 Grease is designed to withstand the extreme temperatures and pressures which occur in high-performance wheel bearings and CV-joints. The excellent high-temperature stability, extreme- pressure protection, and water resistance enables it to out-perform even the best conventional or synthetic greases. Red Line CV-2 Grease can be used in a wide range of applications at temperatures ranging between -100°F to 500°F and provides good oxidation and corrosion resistance, low evaporation and oil separation, and has a minimum effect on rubber seals. Possesses a very high melting point, excellent water washout resistance and superior antiwear which makes it excellent for high temperatures and extreme loads. CV-2 contains an organic moly and is for wheel bearings, high angle and conventional CV joints, chassis lubrication and high temperature, high speed industrial equipment. The exceptional extreme- pressure performance and the fluidity of the synthetic oil allows increases in bearing life of 200% to 800%. Red Line CV-2 Grease will retain its consistency and extreme-pressure performance under high- temperature and high-shear conditions for extended periods, which extends the performance ranges of the lubricated components. Red Line CV-2 will darken after high-temperature use; this darkening will not detrimentally effect the performance of the grease. Although Red Line CV-2 is compatible with small amounts of many petroleum-based greases, it is always good lubrication practice to thoroughly clean out the old grease to eliminate abrasive particles and to minimize the possibility of grease incompatibility.

kmorris
01-30-2008, 03:50 PM
Not sure about ZX1, but if it's Redline CV-2 you're after, I think JRP carries it. They seem to have a lot of Redline stuff.

MARC W
02-01-2008, 10:30 AM
Application is for axles on a formula race car.
Compared to what we currently use (which is very good) this grease is far better, shows no wear and very little needs to be used.
Looks like we may have to call Demon tweeks.