View Full Version : Picton Convoy?
eddie 82
05-27-2004, 02:45 PM
Is anyone interested in a convoy to Picton on Sunday morning?
Say, departing Kennedy Commons (401/Kennedy) at 6am?
Too early? Too late?
Speak now.......
tanney
05-27-2004, 02:51 PM
I would suggest leaving a little earlier than that unless your flying..... It's at least two hours from the east end.
We used to leave at 6:00 am from the Jack Astors parking lot at Scarborough Town Center.
eddie 82
05-27-2004, 03:14 PM
Tanks Joe and Wes......
Initial post updated.
AlienDNA
05-27-2004, 06:20 PM
I'll probably be leaving the house at 6AM, so I'll likely just meet you on the 401.
Suzie
05-27-2004, 07:13 PM
There's a 6 *AM* now too? ;)
Suzie
holliko
05-27-2004, 10:39 PM
Originally posted by eddie 82
Is anyone interested in a convoy to Picton on Sunday morning?
Say, departing Kennedy Commons (401/Kennedy) at 6am?
Too early? Too late?
Speak now.......
I'm in... See you there... CB equiped????
Robert
spoonie
05-27-2004, 11:04 PM
i'll meet at KC at 5:30 - 5:45 am.
how about in the lot by the AMC ? driving out of that one goes right on to the highway.
~spoonie
gatherer
05-28-2004, 06:32 PM
Spoonie I'll be at KC around 5:30 getting a coffee from Tim's ... if you want to meet at AMC I'll drive by and look for your car.
neonstef
05-29-2004, 07:34 PM
I will be there as well 5:30 5:45ish.
Stef
Cliff96
05-29-2004, 10:14 PM
I'll should be there around 545 as well
nitrowsb
05-29-2004, 11:06 PM
We'll be there as well! Wait for us:o :o :D :rolleyes:
gatherer
05-29-2004, 11:53 PM
at 5:45 I'm leaving KC....
ShaneG
05-30-2004, 12:25 AM
Hope to catch up on the HWY.
FRS channel ??
If not...see ya in Picton!
neonstef
05-30-2004, 12:39 AM
Lets use channel 8, sub channel 0 for those who do not have any sub channels.
eddie 82
05-30-2004, 11:59 AM
I feel like an ass..... :(
Sorry if anyone waited for me, as (obviously), I didn't show this morning.
Car started throwing some CELs on the dyno yesterday, so I'm trying to get it up and running again today.
Hope you guys made it ok!
vBulletin® v3.8.1, Copyright ©2000-2012, Jelsoft Enterprises Ltd.