Thread: Introduction
View Single Post
  #5  
Old 01-02-2018, 02:19 PM
1qwkmini 1qwkmini is offline
Registered User
 
Join Date: Aug 2013
Location: Bayfield
Posts: 60
Re: Introduction

In the process of building a cage at the moment.

Do it all at once or just live with the roll bar...unless you want to do a bolt in to start. The bolt in RB can then be removed/shortened/dropped etc for the addition of the front section.

Once you weld in the roll bar, you will need to remove the roof (or cut holes in it...not recommended) or cut the bar out and use riser boxes or similar....this is to allow for a 360 deg welding of all the top tubes. Without the room to access the top of the bar it will be impossible and it then won't pass any race bodies inspection. Welding in a roll bar and then cutting it up to do the cage will likely cost you more $$$ in the end.
Reply With Quote